Handle HW2 + Key K1 + Security Rosette PZ60

Complete coordinated action set of handle, key, and security rosette for entrance doors. When ordering, it is necessary to define the type of material into which the handle will be mounted and also the door opening direction.

Handle HW2 is a luxurious accessory that will give your doors a unique character. With stainless steel mounting and vertical design, this handle is an ideal choice for people looking for an elegant addition to their door panel. Revive your doors and give them a stylish and modern look.

Protect the handle from sun and rain by placing the doors in a shelter or under an overhang. This step will extend its lifespan and preserve its beauty.

To maintain the handle in perfect condition, simple treatment with a wood care set once a year is sufficient.

One-sided key with an oval rosette under the key and a rosette for the lock cylinder.

The rosette for the lock cylinder is attached with two screws. The square shaft is inserted into the lock and then tightened with a nut. In this case, the square shaft functions as an anchoring element on which the key is mounted. This type of mounting is suitable for handle/key combination.

We do not recommend using keys with handles that are not prepared for one-sided mounting.

Rosette PZ60

Exterior rosette PZ 60 is standard delivered in stainless steel version. The rosette has a lock cylinder cover. It is suitable for common cylindrical lock cylinders that protrude to the exterior in the range of 6-7 mm. Rosette height is 11.5 mm.

During installation, it is necessary to pre-drill a hole with a diameter of 3mm with a spacing of 50 mm. The rosette is pushed on and secured after inserting the lock cylinder. Therefore, the rosette cannot be dismounted without removing the lock cylinder.

Rosette PZ58

Exterior rosette PZ 58 is standard delivered in stainless steel version. The rosette is without lock cylinder cover. It is suitable for common cylindrical lock cylinders. Rosette height is 6 mm. The lock cylinder should therefore not protrude significantly more than 6 mm.

During installation, it is necessary to pre-drill a hole with a diameter of 3mm with a spacing of 50 mm. The rosette is pushed on and secured after inserting the lock cylinder. Therefore, the rosette cannot be dismounted without removing the lock cylinder (if the lock cylinder protrudes at least 4 mm).