Handle H3 + Key K1 + Rosette PZ 59

Complete coordinated action set of handle, key, and security rosette for entrance doors. When ordering, it is necessary to define the type of material into which the handle will be mounted and also the door opening direction.

Traditional elegant handle in stainless steel finish of AISI 304 quality. The handle is designed for installation in the wing of entrance doors - not in the door panel.

Door handle can be mounted in plastic or aluminum entrance doors. The handle's mounting spacing is designed so that the handle does not bend. The handle rod is standard delivered with a cross-section of 40 x 20 mm with a wall thickness of 1.5mm. In case of longer dimensions, the handle is used with a cross-section of 40 x 40 mm. The handle can be supplied up to a length of 2600mm.

These handles are in stock for immediate pickup.

If you require a different handle length, we can provide it for you. You should expect a longer delivery time, which is usually 4 - 6 weeks.

One-sided key with an oval rosette under the key and a rosette for the lock cylinder.

The rosette for the lock cylinder is attached with two screws. The square shaft is inserted into the lock and then tightened with a nut. In this case, the square shaft functions as an anchoring element on which the key is mounted. This type of mounting is suitable for handle/key combination.

We do not recommend using keys with handles that are not prepared for one-sided mounting.

Rosette PZ59

Exterior rosette PZ 59 is standard delivered in stainless steel finish. The rosette is without lock cylinder cover. It is suitable for common cylindrical lock cylinders. Rosette height is 10mm. The lock cylinder should therefore not protrude significantly more than 10mm.

During installation, it is necessary to pre-drill a 3mm diameter hole with a spacing of 50mm. The rosette is pushed on and secured after inserting the lock cylinder. The rosette cannot be dismounted without removing the lock cylinder (if the lock cylinder protrudes at least 4mm).

Rosette PZ58

Exterior rosette PZ 58 is standard delivered in stainless steel finish. The rosette is without lock cylinder cover. It is suitable for common cylindrical lock cylinders. Rosette height is 6 mm. The lock cylinder should therefore not protrude significantly more than 6 mm.

During installation, it is necessary to pre-drill a 3 mm diameter hole with a spacing of 50 mm. The rosette is pushed on and secured after inserting the lock cylinder. The rosette cannot be dismounted without removing the lock cylinder (if the lock cylinder protrudes at least 4 mm).